- 您现在的位置：买卖IC网 > Sheet目录1227 > MAX16050EVKIT+ (Maxim Integrated Products)EVAL KIT FOR MAX16050
MAX16050 Evaluation Kit
Component List (continued)
DESIGNATION
OUTPUT1,
OUTPUT2,
U1_CP_OUT,
U1_EN,
U1_ OV_OUT ,
U1_REM,
U1_ RESET ,
U2_CP_OUT,
U2_EN,
U2_ OV_OUT ,
U2_REM,
U2_ RESET
R1, R12, R20, R32
R2, R4, R10, R13,
R22, R24, R30,
QTY
12
4
9
DESCRIPTION
PC mini red test points
86.6k Ω ±1% resistors (0805)
16.5k Ω ±1% resistors (0805)
DESIGNATION
R35
SW1
SW2
U1_VCC, U2_VCC,
VPULLUP
U1
U2
—
—
QTY
1
1
1
3
1
1
32
1
DESCRIPTION
20.5k Ω ±1% resistor (0805)
4-position DIP switch
10-position DIP switch
PC large red test points
4-channel voltage sequencer
(28 TQFN-EP*)
Maxim MAX16050ETI+
5-channel voltage sequencer
(28 TQFN-EP*)
Maxim MAX16051ETI+
Shunts (J1, J2, JU1–JU15)
PCB: MAX16050 Evaluation Kit+
R33, R36
R3, R23
R5, R11, R14, R25,
R31, R34, R37
2
7
30.1k Ω ±1% resistors (0805)
10k Ω ±1% resistors (0805)
*EP = Exposed pad.
Component Suppliers
R6, R26
R7, R27
2
2
634k Ω ±1% resistors (0805)
261k Ω ±1% resistors (0805)
SUPPLIER
Murata
PHONE
WEBSITE
R8, R28
R9, R29
2
2
698k Ω ±1% resistors (0805)
61.9k Ω ±1% resistors (0805)
Electronics
North
America, Inc.
770-436-1300 www.murata-northamerica.com
R15, R21
R16–R19,
R38–R41
0
8
Not installed, resistors—short
(0805)
10k Ω ±5% resistor (0805)
Note: Indicate that you are using the MAX16050 or MAX16051
when contacting these component suppliers.
3) Connect the positive terminal of the 3.5V power
Quick Start
Required Equipment
Before beginning, the following equipment is needed:
? MAX16050 EV kit
supply to the U1_VCC and U2_VCC test points.
Connect the ground terminal of this power supply to
the respective GND test points.
4) Connect the positive terminal of a 5V power supply
to the VPULLUP test point. Connect the ground ter-
?
?
DC power supplies: 3.5V/100mA, 5V/50mA
2-channel oscilloscope
minal of this power supply to the GND test point.
5) Connect oscilloscope channels 1 and 2 to the
U1_ RESET and U2_ RESET test points, respectively.
Procedure
The MAX16050 EV kit is a fully assembled and tested
surface-mount board. Follow the steps below to verify
board operation. Caution: Do not turn on the power
supplies until all connections are completed.
1) Verify that headers J1 and J2 and jumpers
JU1–JU14 are configured for demo mode configu-
ration (see Table 1).
2) Verify that switches SW1 and SW2 are set to the off
position.
Connect the ground leads to the nearby black GND
test points.
6) Turn on the VCC power supply and adjust the volt-
age to 3.5V.
7) Turn on the VPULLUP power supply and adjust the
voltage to 5V.
8) Verify that both U1_ RESET and U2_ RESET signals
are high.
9) The EV kit is ready for further testing.
2
_______________________________________________________________________________________
发布紧急采购，3分钟左右您将得到回复。
相关PDF资料
MAX16929EVKIT+
KIT EVALUATION FOR MAX16929
MAX16946EVKIT+
KIT EVALUATION FOR MAX16946
MAX17015EVKIT+
KIT EVAL FOR MAX17015
MAX17021EVKIT+
EVAL KIT FOR MAX17021
MAX1702EVKIT
EVAL KIT FOR MAX1702
MAX17710EVKIT#
RD ENERGY HARVESTING
MAX19000EVKIT+
EVAL KIT MAX19000
MAX19710EVKIT+
EVAL KIT FOR MAX19710
相关代理商/技术参数
MAX16051ETI+
功能描述:监控电路 Volt Mtr/Sequencer w/Reverse-Seq RoHS:否 制造商:STMicroelectronics 监测电压数: 监测电压: 欠电压阈值: 过电压阈值: 输出类型:Active Low, Open Drain 人工复位:Resettable 监视器:No Watchdog 电池备用开关:No Backup 上电复位延迟（典型值）:10 s 电源电压-最大:5.5 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:UDFN-6 封装:Reel
MAX16051ETI+T
功能描述:监控电路 Volt Mtr/Sequencer w/Reverse-Seq RoHS:否 制造商:STMicroelectronics 监测电压数: 监测电压: 欠电压阈值: 过电压阈值: 输出类型:Active Low, Open Drain 人工复位:Resettable 监视器:No Watchdog 电池备用开关:No Backup 上电复位延迟（典型值）:10 s 电源电压-最大:5.5 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:UDFN-6 封装:Reel
MAX16052AUT+
制造商:Maxim Integrated Products 功能描述:VOLT SUPERVISOR SEQUENCER/MONITOR 6PIN SOT-23 - Rail/Tube
MAX16052AUT+T
功能描述:监控电路 Adj Sequencing / Supervisory RoHS:否 制造商:STMicroelectronics 监测电压数: 监测电压: 欠电压阈值: 过电压阈值: 输出类型:Active Low, Open Drain 人工复位:Resettable 监视器:No Watchdog 电池备用开关:No Backup 上电复位延迟（典型值）:10 s 电源电压-最大:5.5 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:UDFN-6 封装:Reel
MAX16053AUT+
制造商:Maxim from Components Direct 功能描述:MAXIM MAX16053AUT+, SUPERVISORS - Tape and Reel 制造商:Maxim Integrated Products 功能描述:VOLT SUPERVISOR SEQUENCER/MONITOR 6PIN SOT-23 - Rail/Tube 制造商:Maxim 功能描述:Maxim MAX16053AUT+, Supervisors
MAX16053AUT+T
功能描述:监控电路 Adj Sequencing / Supervisory RoHS:否 制造商:STMicroelectronics 监测电压数: 监测电压: 欠电压阈值: 过电压阈值: 输出类型:Active Low, Open Drain 人工复位:Resettable 监视器:No Watchdog 电池备用开关:No Backup 上电复位延迟（典型值）:10 s 电源电压-最大:5.5 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:UDFN-6 封装:Reel
MAX16053UAT+
制造商:Maxim Integrated Products 功能描述:IC - Tape and Reel
MAX16054AZT+
制造商:Maxim Integrated Products 功能描述:ON/OFF CONTROLLER WITH DEBOUNCE AND ?15KV ESD PROTECTION - Rail/Tube 制造商:Rochester Electronics LLC 功能描述: